Picked up the kit online from Scooter's Performance. Just over $100 delivered.

Installation is VERY simple. It only took about 15 minutes and just about anyone should be able to do it.

About the Buller Proof Belt Drive Fix - From the Manufacturer

This amazing part will fix the "grind" associated with starting bikes that have a solid or very rigid belt drive actuation.
The engineered spring and ramped teeth help integrate the teeth before the unit locks in and turns.
Stop grinding your teeth - and the bike's jackshaft all while producing smoother and quieter starts.

Removing the Old Starter Pinion Gear

Remove the starter housing from the motor plate to expose the starter pinion gear.

Starter Housing

Old Starter Pinion Gear From the BDL Kit Installed - You can see the grind marks where it did not engage the ring gear.

Remove the old starter pinion gear from the starter jackshaft. Use a flathead screw driver wedged between the ring gear on the clutch basket and the starter pinion gear to keep it from turning so you can remove the bolt.

Use a Screw Driver to Keep it from Turning to Remove the old Gear

When you remove the old set up from the starter jackshaft there is a spring that is installed on the jackshaft. It probably will not come out with the rest of the assembly so you will need to remove it with a pair of needle nose pliers. I forgot about it at first and could not figure out why I could not get the new coupler the seat all the way on the starter jackshaft.

Old Setup Removed from the Starter Jackshaft

Installing the Bullet Proof Starter Fix

The Bullet Proof Belt Drive Fix Kit comes with the Jackshaft bolt & washer, the pinion gear, the shaft, a spring, the coupler that mates it to the starter jackshaft, and a couple of spacers.

Bullet Proof BDL Starter Fix

Instructions Included with Bullet Proof Starter Fix Kit

To install the fix just assemble the components and slide the coupler onto the starter jackshaft. May take a bit of fiddling to get the pinion gear to slide pass the ring gear. Apply a drop or 2 of red loctite to the bolt and tighten it to 60in. lbs.

Again, use a flathead screwdriver wedged through the ring gear and the pinion gear to keep it from turning so you can tighten it to the proper torque.

Bullet Proof BDL Starter Fix Installed - Notice the bevel on the pinion gear that allows it to engage the ring gear easier.

Try her out. Hit the starter button and the pinion gear should engage the ring gear on the first shot.

Reinstall the starter housing using blue loctite on the 2 bolts.

I have been running it with the Bullet Proof Fix installed for about a week now and it has not missed a beat. If you are running a BDL belt drive and are having problems with the starter just "zinging" from time to time this fix is well worth the money and effort.

Take Care - Ride FREE
Hersey
http://www.custommotorcyclebuilding.com/

Other Resources

Scooter's Performance Where I picked up the Bullet Proof Starter Fix. Lots of other performance parts and great prices. Check them out...

Bullet Proof Jack Shaft - Wow Discussion thread over at Club Chopper. Also in their news Bulletproof Belt Drive Fix.

Belt Drives Limited (BDL) - Belt Dive Kits and Parts.